Powerfix Profi HG03064B Bedienungs- Und Sicherheitshinweise Seite 54

Then press the PUSH button
pressed down. Wait for a short double signal
tone. It means, the calibration is completed.
Now, guide the detector, over the surface to
be examined. It is possible that during this
some short signal tones may sound. These are
however without any meaning, so long as no
intensity display
display.
 
I f there is an object, for which the search is
activated, in the vicinity of the detector,
several bars appear at first on the intensity
display. As proximity to the search object in-
creases, the number of bars increases on the
intensity display (Fig. C).
 
I f the detector is exactly over the search
object, a continuous signal tone sounds.
 
I n the case of a search for a power line, the
voltage sign ( )
to the intensity display.
 
A lways guide the detector in a straight line
in all the searches. To locate the object more
precisely, guide the detector over the surface
to be examined in a forward direction for
both Metal and Wooden beam search. For
the Void search, the detector can be guided
in both forward and backward directions. For
the AC search, the detector can be guided in
all the four directions (Fig. B).
  
I ntegrated Pencil:
A pencil
hole, which is located on the right side of the
product. When necessary, the pencil
be taken out from the pencil hole. Care should
taken while inserting back the pencil
pencil hole of the product. Make sure to insert
54 GB/MT
appears in the detector
11
also appears in addition
10
has been included on the pencil
4
and keep it
5
can
4
to
4