Miomare HG00476B Montage-, Bedienungs- Und Sicherheitshinweise Seite 7

CAUTION! RISK OF DAMAGE TO
PROPERTY! Have the installation done by
experienced persons only. Leaks or escape
of water can lead to serious damage to
buildings or household fittings and furniture.
Check all connections for leaks carefully.
Ensure that all seals are correctly seated to
prevent leakage of water.
The spout can be swiveled to your desired
position. Make sure the spout is always
positioned within the area of the sink,
otherwise escape of water can lead to
serious flooding to your house or building.
CAUTION! DANGER OF SCALDING!
When making the hot water setting please
ensure that the temperature of the water is
not too high.
Before installation, make yourself familiar
with all the existing services, e.g. water
connection and stopcocks.
Please read carefully through these operating
instructions before installing and using
the product. Keep all the safety advice
and instructions in a safe place for future
reference!
˜ Installation
˜ Installing the tap
Turn off the main water supply to prevent
serious leakage of water. Allow any
remaining water in the pipework to drain.
Install the tap as shown in Figs. A - H.
m
CAUTION! Do not bend the hoses or place
them under tension. Otherwise material
damage could result.
˜ Flushing the tap
The tap must be flushed through before first
use to remove any dirt. To do this, follow
these steps (see Fig. H):
6 GB/CY
Screw the aerator
Open the main water supply and allow the
water to run for two minutes.
Then screw the aerator
˜ Setting the temperature limiter
The cartridge with setting ring
temperature limiter. This function is not activated
in the factory (neutral setting).
m
CAUTION! Change the temperature limiter
setting only after the tap has been installed.
Follow Fig. I to set the temperature limitation.
Turn off the main water supply.
Remove the small plastic cover
by a small flat screwdriver.
Release the locking screw
anticlockwise using a hexagonal key.
m
CAUTION! Do not take the screw
completely out; just loosen it until the control
lever can be easily taken off.
17
Take off the control lever
Loosen the cartridge covering ring
hand. Then, screw off the cartridge retaining
ring by using a pipe wrench.
21
Now pull the cartridge with setting ring
upwards with the help of a screwdriver.
Note: Do not remove the cartridge with
setting ring .
22
Place the cartridge with setting ring
desired position (see Fig. J).
Tighten the cartridge retaining ring
the tap body again by using a pipe
16
wrench. Then, tighten the cartridge covering
ring by hand.
20
off.
2
on again.
2
in this unit has a
22
carefully
18
by turning it
19
.
17
by
20
22
in the
22
onto
21