Additional Notes; Vibration Mode; Temperatures And Washing Times; Thermal Relay - Centrostyle 5400 Gebrauchs- Und Wartungshandbuch

ADDITIONAL NOTES

Vibration modes.
The three vibration modes make it possible to perform washing with different energy types.
A
B
C

Temperatures and washing times.

The heat reinforces the action of the ultrasounds and the detergent helping to
remove dirt. Objects that are delicate, have fragile finishes, treatments and
decorations should be washed with care. In order to avoid damage to
delicate objects, programme moderate times and temperatures.
The optimum cleaning time for a typically dirty pair of spectacle frames without
lenses is from 3 - 5 min.
We do NOT recommend performing washing cycles on spectacles assembled
with treated, organic lenses (anti-dazzle, mirror lenses, anti-scratch lacquering).
The combined action of ultrasound and high temperature could damage the lenses.
If it is not possible to remove the lenses, programme short cycles (1 - 3 minutes)
using cold water and setting the temperature to the minimum (15°C).

Thermal relay.

The Ref. 5410 and 5420 cleaners have a protection system that
switches them off if the temperature in the tank goes over 70°C.
This temperature
ultrasound use. When the temperature falls, the cleaner can be restarted
pressing "S-Stop" ³.
GB
9
A - Continuous vibration transmits
the most energy and is recommended for
washing equipment and parts that are
very dirty.
On delicate objects perform short
washing cycles.
B - Pulsating vibration transmits
less energy than continuous vibration,
but helps remove dirt from zones that are
very irregular and from difficult-to-reach corners.
C - Intermittent vibration is obtained
by alternating moments of pause with
continuous vibration. It is more delicate
and allows dirt removed during washing
to deposit itself on the bottom of the tank.
could be reached under continuous