Centrostyle 5400 Gebrauchs- Und Wartungshandbuch Seite 29

Data shown on the numerical displays:
Display º : time in minutes.
• During washing the figure shown counts down, indicating the time
remaining and the point on the right flashes.
• When the "S-Stop" ³ or "Prog" ´ keys are pressed, it momentarily shows
the No. of the set program.
• At the end of the washing cycle it show the total time set and the point on
the right switches off.
Display ² : temperature in degrees centigrade
(shows only the set value. It is not a thermometer).
• When the cleaner is on stand-by and the heating is activated, the figure
shown flashes. During washing the figure is always ON and when the
point on the right turns on this indicates that the heating is working.
The cleaner can be put into operation in 3 modes:
Press the "S-Stop" key ³ to start washing straight away, if the program
1
is the suitable for your needs. Press twice to start washing whilst the water
is being heated.
Set the time, using the + · and - » keys, from 1 to 30 min, without
2
changing the type of vibration and the temperature, then press the
"S-Stop" key ³ .
Select the desired program using the " Prog" key ´ and
3
then press the "S-Stop" key ³ .
Each time a key is pressed and at the end of the washing cycle, a
"Beep" is emitted as confirmation.
Additional notes (see Page 9)
GB
8