Medium Version, Ref. 5410 - Centrostyle 5400 Gebrauchs- Und Wartungshandbuch

Medium version, Ref. 5410.

This model can perform washing cycles which can be set from 1 to 30 minutes (in
steps of 1 min.) with 3 different vibration modes.
1 Select the desired time using the + · and - » keys. Each time
the keys are pressed the value on the display º increases or decreases and a
"beep" is emitted as confirmation.
If held down, the value increases or decreases rapidly.
2 Press the "S-Stop" key ³ (double start - stop function) to begin the cleaning
cycle. Whilst the cleaner is working the display indicates the time remaining in
minutes and the point on the right flashes.
3 Press the "S-Stop" key ³ again at any time to stop the washing.
4 At the end of the washing cycle a triple "beep" is emitted.
The display indicates the total time set.
In order to set the vibration mode and store the data:
1 Hold down the "Set" key ¿ for about 2 sec. The display º flashes.
2 Set the washing time using the + · and - » keys.
3 Press the "Set" key ¿ again for 2 sec. and select the vibration mode,
continuous, pulsating or intermittent ¶, using the + · and - » keys.
The difference between the types of vibration is explained on Page 9.
4 Press the "Set" key ¿ again for 2 sec. to exit the programming
mode. Activate the cleaner with the "S-Stop" key ³. This data
remains in the memory even when the cleaner is switched off.
This model is not equipped with independent tank heating. However,
the liquid detergent heats up during operation due to the effect
of the ultrasonic energy. After running for about 15 minutes, the water heats up;
temperature increases in proportion to the cleaner's use. If it is running
in continuous mode it can reach more than 60° C. This is to be considered normal.
Additional notes (see Page 9)
Ref. 5410
³
·
GB
5
¶
º
¿
»