Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
• Gain Controls with LED Overload Indicator and Pull Phase
• Aural Enhancer Control (Channel 1)
• Bass Controls
• Mid Range Level Controls
• Treble Controls
• Effects Blend Controls
• Reverb Control
• Master Volume Control
• Power On/Off Switch
REAR PANEL FEATURES
• Line Fuse
• A/C Power Cord Receptacle
• Stereo Headphones Jack
• Effects Send Jacks
• Effects Return Jacks
• Balanced Line Out
• Line Out Jacks (Channel 1 or 2)
• Post-Reverb Return Jack
• Reverb Footswitch Jack
CROSSOVER PANEL FEATURES
• Tweeter Attenuator Control
• Extension Speaker Out Jacks (Speakon and 1/4")
GETTING STARTED
Remove the AC cable from the accessory pack and connect it from the amplifier to a standard wall outlet. Make sure that the Gain
and Master Volume controls are set to the minimum position (fully counter-clockwise). Locate the power switch on the right side
of the front of the unit and turn on the amplifier. Upon powering up, don't be surprised if you hear a small pop. This is absolutely
normal.
Plug your instrument into the desired input jack (refer to "Front Panel Features" for greater detail). Turn your instrument's volume up
to at least 75% of maximum and slowly adjust the gain control. Once you begin to play your instrument and you see the yellow light
over the gain control illuminate, back off the gain a bit. Now turn up the
instrument amplified through the California Blonde. For more detailed information, please read the entire manual carefully so that you
can fully realize the California Blonde's potential.
Master Volume
and you should hear the sound of your
CALIFORNIA BLONDE • 7
Werbung
Inhaltsverzeichnis
