Christopeit Sport RS 100 Montage- Und Bedienungsanleitung Seite 14

Step 4:
Attach the back cushion (32) at seat support (5)
1. Place the backside of back cushion (32) against den seat support (5)
so that the holes align.
2. Screw the back cushion (32) at seat holder (5) tightly by using screws
M6x35 (45) and washers 6//12 (53).
Step 5:
Attach the computer holder (2) at main frame (1).
1. Place the computer holder (2) against the main frame (1) and connect
the plug for the computer cable (25) with the matching plug for the
sensor cable (9).
2. Put the computer holder (2) onto the locator provided for it at the main
frame (1). Ensure that the cable connection made are not squashed.
Screw the computer holder (2) at main frame (1) in straight direction
with screws M8x20 (47), spring washers (62) and
arc washers 8//20 (46).
Step 6:
Attach the pedals (33L+33R) and computer (11).
1. Screw the right pedal (33R) into the locator on the right-hand side
(as seen in exercise position) for the pedal crank (13) (Warning! The
screw direction is clockwise).
2. Screw the left pedal (33L) into the locator on the left-hand side (as
seen in exercise position) for the pedal crank (13) (Warning! The
screw direction is anti-clockwise).
3. Then mount the pedal straps left and right (35L+35R) on the associated
pedals (33L+33R). (The pedals are marked with sign "L" for Left and
"R" for Right.)
4. Take the computer (9) that has been supplied out of the packaging
and insert the batteries (Type "AAA"-1.5 V pencells) by watching
for the right polarity on the back of the computer (9). (Batteries for
the computer are not included in this item. Please buy them at your
located market.)
5. Put the plug of connection cable (25) into the cable socket from
monitor (11)
6. Attach the monitor (11) to computer holder (2) and tighten with screws
M5x12 (63).
(Attention: Ensure that the cable loom were not crunch or pinch
during installation.) The screws for computer you find on backside of
computer.
14