Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1 RECOMMENDATIONS
This cleaning and sanitizing manual forms an integral part of the ice-cube maker (also more simply called
"appliance" in the text) and must be kept for possible future consultation.
In the event of the appliance being sold or transferred to another person, this manual must be handed over to
the new user, in order to enable him to become familiar with the operation of the equipment and the
corresponding advice and recommendations.
This cleaning and sanitizing manual does not replace the instruction book supplied with the ice maker, which
should be referred to for all subjects not covered by this manual; in particular, please refer to the instruction
book for the start-up procedure, connection of the appliance to the electricity mains and water supply, and
cleaning of components not expressly mentioned in the cleaning and sanitizing manual.
The frequency of cleaning and sanitizing operations can vary, depending on:
•
temperature and environmental conditions
•
temperature and quality of water (hardness, presence of grit, etc.)
•
quantity of ice produced, or time of use of ice-cube maker
•
periods of non-use of ice-cube maker
TO ENSURE CORRECT CLEANING AND SANITIZING OF THE ICE-CUBE MAKER, PERFORM THE OPERATIONS
DESCRIBED IN THIS MANUAL AT LEAST ONCE A MONTH.
!! IMPORTANT:
•
the operations described in this manual must only be performed by skilled, authorised personnel
•
the appliance must be installed in a hygienically clean location; avoid premises such as cellars and
storerooms, because poor hygiene promotes the formation and proliferation of bacteria in the ice-cube
maker
•
a cleaning and sanitizing kit specifically designed for this appliance is available from your dealer
•
do not use corrosive substances to remove limestone from the appliance, because this will invalidate
the guarantee, and may cause serious damage to the materials and components of the appliance
•
gloves suitable to protect against cuts must be worn when performing all operations involving handling
of sheet metal parts in particular
•
Gloves suitable to protect the skin against the substances used must be worn when performing all
cleaning and sanitizing operations
•
wear suitable goggles during cleaning and sanitizing operations to protect the eyes against splashes of
the substances used
•
take care not to spill water or solutions on the wiring or the power cable
2 CLEANING
1.
wait for ice cubes to drop, switch off appliance, disconnect from the electricity mains supply and remove
front panel (Fig. 1)
2.
remove flag support assembly (1 in Fig. 2) and ice-cube slide (2 in Fig 2) and extract overflow pipe (3 in
Fig 2) to drain water present in basin
3.
reposition overflow pipe and fill basin with a 25% solution of water and white vinegar. Refer to the table
for the amount of solution required, depending on daily output (Fig. 3)
4.
refit front panel and operate appliance for five one-minute periods, with a five-minute interval between
each
!! IMPORTANT: The pump must be in operation during cleaning cycles (check that water is sprayed). If it is not,
immediately adjust the timer regulation screw by turning it clockwise until the indicator on the pin exits from
the zone marked DEFROST. To reach timer, remove grille on right-hand side of appliance with a Phillips
screwdriver, and regulate timer with a flat-head screwdriver (Fig. 4).
7
Werbung
Inhaltsverzeichnis
