Herunterladen Inhalt Inhalt Diese Seite drucken

RIB TOUCH Wi-Fi Bedienungsanleitung Seite 18

Mechanische kontaktleiste ohne kabel
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

G
B
12 - Insert lower cover into notch and fasten with screws (fig. 17).
13 - Insert upper cover and fasten with screws.
14 - Check functioning of TOUCH Wi-Fi as described under the paragraph of "CHECK
PROPER FUNCTIONING".
IDENTIFICATION
Each TOUCH Wi-Fi is supplied with microswitches in the OFF position to prevent batteries
from becoming discharged when not in use (if connected).
Each TOUCH Wi-Fi must be ABSOLUTELY unequivocally identified by putting only one of
the six microswitches in the ON position (SW2).
Only one of the six microswitches must be in the ON position and the identification must be
different for each TOUCH Wi-Fi.
Note: IDENTIFY TOUCH Wi-Fi CONTAINERS BY APPLYING NUMBERED ADHESIVE LABEL
(SUPPLIED) ON OUTSIDE OF EACH CONTAINER.
Identification of containers serves to rapidly replace dead batteries in TOUCH Wi-Fi indicated
by EDGE LED on MASTER Wi-Fi card.
EXAMPLE OF IDENTIFICATION OF A TOUCH Wi-Fi
STRIP ON A MASTER Wi-Fi
6
5
4
3
2
ON
1
MASTER Wi-Fi
MEMORIZATION
After identifying the TOUCH Wi-Fi, put the microswitches corresponding to the MASTER
Wi-Fi in the ON position and memorize the codes of the TOUCH Wi-Fi:
- Press the PROG RX key located on the MASTER Wi-Fi=> the bicolor EDGE PHOT 1 LED will
flash red for one minute (the time needed to execute memorization).
- Press the PROG TX key on the TOUCH Wi-Fi with microswitches 1 set to ON => on the
MASTER Wi-Fi the bicolor EDGE PHOT 1 LED flashing red will become green and a buzzer
will signal that memorization of the TOUCH Wi-Fi is correct, after which the bicolor EDGE
PHOT 2 LED immediately starts flashing red for one minute (time needed to execute
memorization) l.
- If other TOUCH Wi-Fi are not memorized, let one minute pass and the bicolor EDGE PHOT
2 LED turns off; or press the PROG. RX key four times to end the memorization procedure
=> all bicolor EDGE PHOT LEDs must be off.
EXAMPLE OF IDENTIFICATION OF 3 TOUCH Wi-Fi STRIPS
ON A MASTER Wi-Fi
6
5
4
3
2
1
TOUCH Wi-Fi 1
MASTER Wi-Fi
1
2
1
2
6
5
4
3
2
ON
1
TOUCH Wi-Fi 1
18
Insertion
OFF
3
4
5
6
ON
3
4
5
6
6
6
5
5
4
4
3
3
2
2
1
1
TOUCH Wi-Fi 2
TOUCH Wi-Fi 3
PROG RX
BICOLOR LED 1
17
6
5
4
3
2
1
12/24V ac/dc

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis