General Cleaning And Maintenance Work; Changing The Blade; Storage; Disposal /Enviromental Protection - FLORABEST FRM 1200 D3 Originalbetriebsanleitung

GB IE
General Cleaning and
Maintenance Work
Do not hose down the lawnmower
with water.
• Always keep the equipment clean. To
clean, use a brush or cloth but no de-
tergent or solvent.
• After mowing, use a piece of wood
or plastic to remove adherent plant
remains from the wheels, ventilation
holes, ejection hole and blade area.
Do not use hard or pointed objects, as
these may damage the blade.
• Before each use, check the lawnmower
for obvious defects such as loose, worn
or damaged parts. Check that all nuts,
bolts and screws are sitting firmly.
• Check the covers and protective de-
vices for damage and check that they
are sitting correctly. Replace them if
necessary.
• Oil the wheels from time to time.

Changing the Blade

If the blade is blunt, it can be sharpened
by a specialist workshop. If the blade is
damaged or showing signs of imbalance,
it must be replaced (see chapter on "Spare
Parts").
I
1. Turn the equipment over.
2. Use sturdy gloves and hold the
blade (18) firmly. Turn the blade
screw (17) anticlockwise off of
the motor spindle (19) using a
screwdriver (AF 13 mm).
28
3. Install the new blade (18) in the
reverse order. Ensure that the
blade (18) is positioned correctly
and the screw (17) tightened
firmly. The Groove of the blade
(18) must be planned with the
surveys of the motor spindle
(19).

Storage

• Keep the equipment dry and out of
reach of children. Loosen the wing nuts
(2) and fold down the handle bar (1)
so the equipment takes up less space.
Ensure that the cable is not caught.
• Allow the motor to cool before storing
the equipment in a confined space.
• Do not cover the equipment with nylon
bags as moisture could build up.
We will not be liable for damages caused
by our equipment where these are caused
by improper repair or the use of non-
original parts or by use other than for the
intended purpose.
Disposal /Enviromental
Protection
Be environmentally friendly. Return the
tool, accessories and packaging to a recy-
cling centre when you have finished with
them.
Machines do not belong with do-
mestic waste.
• Hand over the device at an utilization
location. The plastic and metal parts
employed can be separated out and
thus recycled use can be implemented.
Ask our Service-Center for details.