Electrical Safety; Assembly; The Curved Handle And Wheels - FLORABEST FRM 1200 D3 Originalbetriebsanleitung

that we have authorised.
• Keep the equipment in a dry
location and out of reach of
children.
• Handle the equipment with
care. Keep tools sharp and
clean, in order to facilitate bet-
ter and safer work. Follow the
maintenance instructions.
• Wear protective gloves when
changing the cutting device.
• Regularly check the grass col-
lection device for wear and
strains. For safety reasons, re-
place worn or damaged parts.
When adjusting the blades,
take particular care to avoid fin-
gers being trapped between the
rotating blades and fixed parts
of the machine.
• Check that only replacement
tools authorised by the manu-
facturer are used.
• When servicing the cutting bla-
de on it that even if the voltage
source is switched off, the cut-
ting blade can be moved.
• Allow the motor to cool before
storing the equipment in a con-
fined space.
CAUTION! The following
states how to avoid accidents
and injuries due to electric
shock:

Electrical Safety:

• Ensure that the mains voltage
matches the specifications on
the rating plate.
• If possible, connect the equip-
ment only to a socked with a
residual current-operated protec-
tive device (RCD) with a release
current of more than 30 mA.
• Avoid bodily contact with
earthed parts (e.g. metal fenc-
es, metal posts).
• To fix on the power cable, use
the cable suspension intended
for the purpose.
• Keep the power cable away
from the cutting tool when work-
ing. The cutting blades may
damage the power cable and
result in contact with live parts.
Always run the power cable be-
hind the operator.
• Do not use the power cable to
pull the plug from the socket.
Protect the power cable from
heat, oil and sharp edges.

Assembly

Disconnect the plug before any
work on the equipment. There is a
risk of injury.
Assembling the Curved
Handle and Wheels
B
1. Insert the lower bar (3) into the
slot on the lawnmower housing
(6). Compare with the figure
2. Fix the bar (3) using the en-
closed screws (13).
3. Screw all four wheels (5) with
the fittings (5.1) onto the lawn
mower housing (6). The single
wheel adjustment has always to
be at least at one axis.
C
4. Fix the curved handle (1) using
the enclosed screws (14) and the
wing nuts (2) on the lower bar
(3). There are two possible posi-
tions.
GB IE
A
.
25