Assembly; Assembling The Curved Handle; Assembling The Grass Box - FLORABEST FRM 1200 C3 Betriebsanleitung

Electrical Safety:
• Ensure that the mains voltage matches
the specifications on the rating plate.
• If possible, connect the equipment only
to a socked with a residual current-
operated protective device (RCD) with a
release current of more than 30 mA.
• Avoid bodily contact with earthed
parts (e.g. metal fences, metal posts).
• Use only authorised power cables of
type H05RN-F, which are no more than
75 m long and suitable for outdoor
use. The power cable wire cross sec-
tion must be at least 2.5 mm
completely unroll cable drums before
use. Check the cable for damage.
• To fix on the power cable, use the
cable suspension intended for the pur-
pose.
• Keep the power cable away from the
cutting tool when working. The cutting
blades may damage the power cable
and result in contact with live parts. Al-
ways run the power cable behind the
operator.
• Do not use the power cable to pull the
plug from the socket. Protect the power
cable from heat, oil and sharp edges.
• Switch off the equipment and discon-
nect the plug from the socket if the
power cable is damaged. If the power
cable is damaged, it must be replaced
by the manufacturer, the customer serv-
ices of the same, or a qualified person,
in order to avoid hazards.
• Do not connect a damaged power
cable to the mains. Do not touch a
damaged power cable when it is
connected to the mains. A damaged
power cable may result in contact with
live parts.

Assembly

Disconnect the plug before any
work on the equipment. There is a
risk of injury.
Assembling the Curved
Handle
B
1. Insert the lower bar (3) into the
2. Fix the bar (3) using the en-
3. Screw all four wheels (5) onto
C
. Always 4. Fix the curved handle (1) using
2
5. Clip the cable holder (8) into the

Assembling the Grass Box

D
1. Connect the two pieces of the
2. Connect the handle (15) in one
slot on the lawnmower housing
(6).
closed screws (13).
the lawn mower housing (6). All
of the wheels must be set to the
same height.
the enclosed screws (14) and the
wing nuts (2) on the lower bar
(3). There are two possible posi-
tions.
bar (3) and thus fix the cable.
When both wing nuts are loosened,
the curved handle can be folded
down for storing the equipment.
Ensure that the power cable is not
caught.
collection box (4).
of the two pieces of the collec-
tion box (16).
Do not work with the lawn mower
without impact protection. There is
a risk of injury.
We recommend always using the
grass box when working with the
lawn mower, otherwise the mow-
ing result may be significantly im-
paired.
GB IE
9