Handling Electrical Cables - Dometic FRESHWELL FW3000 Montageanleitung

Safety and installation instructions
• Installation, maintenance and repairs of the under-bench air
conditioner must only be carried out by qualified personnel who are
familiar with the risks involved when handling refrigerant and air
conditioning systems as well as the relevant regulations. Inadequate
repairs may cause serious hazards. For repair service, please contact
the service centre in your country (addresses on the back page).
• A damaged supply cord must be replaced by the manufacturer or a
qualified person in order to avoid a hazard.
!
CAUTION!
• The under-bench air conditioner must be installed securely so that it
cannot fall down.
• Only operate the under-bench air conditioner if you are certain that
the housing and the cables are not damaged.
• Do not use the under-bench air conditioner near flammable fluids.
• Make sure no combustible objects are stored or installed near the air
outlet. A distance of at least 50 cm must be kept.
• Do not reach into air outlets or insert any foreign objects in the device.
A
NOTICE!
• Only use the device as intended.
• The under-bench air conditioner is not suitable for use in agricultural or
construction vehicles.
• Do not make any alterations or conversions to the device.
• If faults occur in this refrigerant circuit, the system must be checked by
a specialist company and repaired properly. The refrigerant must
never be released into the air.
2.2

Handling electrical cables

!
WARNING!
• The electrical power supply may only be connected by a qualified
electrician (e.g. VDE 0100, Part 721 in Germany).
!
CAUTION!
• Attach and lay the cables so that they cannot be tripped over or
damaged.
4
FreshWell3000
EN