Inhaltsverzeichnis
Werbung
H
/a
i
eaD
cceSSory
nStallation
Installing the cup head, 3" head or other head attachments:
1. Move the 3-way rocker switch to the center, off/standby position. For the Fixed
Speed Mini Vortex Mixer disconnect the power cord from the wall outlet.
2. If using an Insert Retainer with tube holder, insert foam tube holder into Insert
Retainer by lining up the recessed notches of the foam with the fingers of the
retainer. Push foam to the bottom of the retainer.
3. Place head on post of the unit, aligning the flat "alignment mark" inside of the head
mounting hole with the flat "alignment mark" on the post.
4. Press center of head down firmly until it snaps into place. DO NOT use a 3" head
without the 3" rubber head cover. Add samples to attachments after the head is
secured onto the Mini Vortex Mixer. Be sure samples are secure before turning unit
on.
5. To remove an installed head, hold the Mini Vortex Mixer housing with one hand
and firmly pull the head straight up. Larger heads may require using both hands to
force head off post. Remove samples before removing attachments.
2.
3.
4.
i
nStructionS
5.
Installing Vessel Harness:
1. Install Insert Retainer without foam tube holder onto Mini Vortex Mixer.
2. Stretch vessel harness elastic bands over opposite fingers of the Insert Retainer.
Place bands on either upper or lower notches of the retainer.
3. Place sample in center of the harness bands. Be sure sample is secure before
turning unit on.
EN
8
8
Werbung
Inhaltsverzeichnis
