Inhaltsverzeichnis
Werbung
H
/a
i
eaD
cceSSory
nStallation
Installing Single Tube Holder:
1. Move the 3-way rocker switch to the center, off/standby position. Single Tube
Holder should NOT be used on the Fixed Speed Mini Vortex Mixer.
2. Remove cup head, or any other accessory from the Mini Vortex Mixer.
3. Remove the adhesive backing from adapter plate and line up the opening of the
adapter plate over the opening of the housing. Press down firmly to ensure a
proper bond between the adaptor and the unit. Align the base plate of the Single
Tube Holder with the adaptor plate from the previous step. Keep the center
openings of the plates concentric to avoid mechanical interference. The magnets
will hold the Single Tube Holder in place. To realign this attachment, pull up from
the handle until the magnets release, check the alignment and place again.
4. Align the base plate of the Single Tube Holder over the post of the Mini Vortex
Mixer with the two Single Tube Holder alignment posts at the back of the unit.
Lower Single Tube Holder onto the adapter plate, the magnets will hold the Single
Tube Holder in place. To realign this attachment, pull up from the handle until the
magnets release, check the alignment and place again.
5. Now that the Single Tube Holder is in place, attach the cup head on the post of the
unit, aligning the orientation arrow towards the rear of the unit.
6. Lift up on the spring loaded upper portion of the Single Tube Holder and slide a
2.5 to 4.5" (6.4 to 11.4cm) long tube on the cup head so that the tube is aligned
in the middle. The 0.5mL Micro-Tube Holder or the 1.5 to 2mL Micro-Tube Holder
will also fit into the Single Tube Holder. You are now ready to mix your sample.
9
i
nStructionS
2.
3.
5.
EN
4.
5.
Werbung
Inhaltsverzeichnis
