Kemper VacuFil 125 Betriebsanleitung Seite 82

Touch display (pos. 1)
•
Various options and parameters can be set via the touch display. See the section
"Settings in the touch display".
Device pushbutton I/O 2)
•
Pressing the button turns the product on and off.
The green indicator light on the button's control panel indicates that the product is
operating correctly or, if the optional start-stop sensor is in use, that it is ready for
operation.
NOTICE
Signal horn (Pos. 3)
•
Reliable capture of welding fumes is only possible with sufficient extraction capacity.
As the dust accumulation in the filter increases, its resistance to through-flow increases
and suction decreases.
As soon as it drops below a minimum value, the signal horn will sound.
If the integrated cleaning is no longer sufficient, a change of filter is required.
The same happens if the suction power is reduced too much by closing the extraction
hose.
The remedy is to check for blockages.
NOTICE
Sufficient suction power for collecting the pollutants through the welding fume
extraction burner is guaranteed in manual operation!
Start-stop socket (pos. 4)
•
Optional automatic start-stop system.
1502649-00 - 82 -
EN