1. In the first step, tighten the star knob screw (pos. 3) through the corresponding hole in
the product. Allow the disc (pos. 2) to engage in the spherical head of the star grip
screw (pos. 3).
2. Position the dust collector (pos. 1) so that it and its seal both rest on the sealing surface
of the product.
3. Tighten the star knob screw (pos. 3) until the dust collector (pos. 1) and its seal both
rest tightly against the sealing surface of the product. Make sure that the seal on the
dust collector (pos. 1) is not damaged.
1502649-00
- 80 -
EN