Main Screen - voestalpine URANOS 4000 AC/DC Gebrauchsanweisung

6 Main adjustment handle
Allows the welding current to be continuously adjusted.
Allows entry to set up, the selection and the setting of
the welding parameters.
7 Processes/functions
Let you select the various system functions (welding
process, welding mode, current pulse, graphic mode,
etc.).
8 Not used
9 Programs
Allows the storage and management of 64 welding
programs which can be personalised by the operator.
10 Signal cable (CAN-BUS) input (RC)

3.3 Main Screen

Allows the control of the system and of the welding process,
showing the main settings.
1 Measurements
During the welding operation, the real current and volt-
age measurements are shown on the LCD display.
1a Welding current
1b Welding voltage
2 Welding parameters
2a Welding parameters
Select the required parameter by pressing the encoder
button.
Adjust the value of the selected parameter by rotating
the encoder.
2b Parameter icon
2c Parameter value
2d Unit of measurement of the parameter
3 Functions
Allow the setting of the most important process func-
tions and welding methods.
34
3a VRD Voltage Reduction Device
Shows that the no-load voltage of the equip-
ment is controlled.
3b Allows the selection of the welding process
MMA
TIG DC
TIG AC
3c Allows the selection of the welding method
Direct polarity
Reverse polarity
Alternating current
3d
Synergy
Allows you to set the best arc dynamics, select-
ing the type of electrode used:
STD Basic/Rutile
CLS Cellulose
CrNi Steel
Alu Aluminium
Cast iron Cast iron
Selecting the correct arc dynamics enables maximum
benefit to be derived from the power source to achieve
the best possible welding performances.
Perfect weldability of the electrode used is not guaran-
teed (weldability depends on the quality of the consum-
ables and their preservation, the operating and welding
conditions, the numerous possible applications, etc.).
3e Allows the selection of the welding method
2 Step
4 Step