System Presentation; General; Front Control Panel; Starting Screen - voestalpine Böhler Welding URANOS 5000 PME Betriebsanweisung

- Connect the red colored
inlet quick connector of the cooling unit.
- Connect the blue colored
outlet quick connector of the cooling unit.
- Connect the MIG torch (23) to the central adapter (24), ensur-
ing that the fastening ring is fully tightened.
- Connect (25) the earth clamp to the negative socket (-) (26) of
the power source.

3 SYSTEM PRESENTATION

3.1 General

They are fully digital multiprocessor systems (data processing on
DSP and communication over CAN-BUS), capable of meeting
the various requirements of the welding world in the best pos-
sible way.
The presence of a powerful microprocessor allows full control of
all the welding functions, making this system suitable for various
types of welding process such as MMA, TIG DC LIFT START,
MIG/MAG, Pulsed-MIG/MAG, Double Pulsed-MIG/MAG.

3.2 Front control panel

1 Power supply
Indicates that the equipment is connected to the mains
and is on.
2 General alarm
Indicates the possible intervention of protection devices
such as the temperature protection (consult the "Alarm
codes" section).
28
water pipe of the torch to the
water pipe of the torch to the
3 Power on
Indicates the presence of voltage on the equipment
outlet connections.
4 Signal cable (CAN-BUS) input (RC)

3.3 Starting Screen

When switched on, the generator performs a succession of
checks in order to guarantee the correct operation of the system
and of all the devices connected to it.
At this stage the gas test is also carried out to check the proper
connection to the gas supply system (system for automation and
robotics).

3.4 Rear panel

1 Off/On switch
Turns on the electric power to the welder.
It has two positions, "O" off, and "I" on.
2 Signal cable (CAN-BUS) input (RC)
3 Signal cable (CAN-BUS) input (Cable bundle)
4 Gas fitting (TIG)
5 Power supply cable
Connects the system to the mains.