WAGNER WallPerfectW 995 Originalbetriebsanleitung Seite 41

WallPerfect W 995 WallPerfect W 995
Problem
Atomisation too
coarse
Spray jet is uneven/
not constant
Coating material
causes "paint tears"
Too much fog of
coating material
(Overspray)
Width of paint
spray cannot be
adjusted
Cause
•
Material volume too large
Material volume setting
turned too far to the right
•
Nozzle contaminated
•
Viscosity of coating material
too high
•
Air ilter heavily soiled
•
At high quantity of material,
narrow spray jet selected
(red)
•
Coating material in
container running out
•
Nozzle seal worn
•
Air ilter heavily soiled
•
Filter clogged at suction
hose
•
Too much coating material
applied
•
Viscosity of coating material
too low
•
Distance to the object too
large
•
Too much material quantity
•
At a low quantity of material,
wide spray jet selected
(green)
•
Adjustment ring is not
connected to the peg on the
air cap
•
Air screen is clogged up
Remedy
➞ Turn the material volume
setting to the left
➞ Clean
➞ Dilute further
➞ Change
➞ Switch to wide spray jet
(green)
➞ Reill
➞ Replace
➞ Change
➞ Clean ilter
➞ Turn the material volume
setting to the left
Spray excess material on the
wall using the inking roller
➞ Reduce the quantity of
material and apply in several
layers
➞ Reduce distance
➞ Turn the material volume
setting to the left
➞ Switch to narrow jet spray
(red)
➞ Connect adjustment ring
and peg
➞ Disassemble and clean the
spray head
GB D
39 39