Angle Grinder - Hilti AG 125-7SE Original Bedienungsanleitung

CAUTION Use of this hood for working on metal is prohibited.
3.8 DC-EX 125/5"C dust hood for cutting (accessory)
Use the DC-EX 125/5"C dust hood when cutting masonry and concrete.
CAUTION Use of this hood for working on metal is prohibited.
4 Consumables
Only synthetic resin-bonded, fiber-reinforced discs with a maximum diameter of Ø 125 mm which are
approved for use at a rotational speed of at least 11,500/min and a peripheral speed of 80 m/s may be used.
The maximum grinding disc thickness is 6.4 mm and the maximum cutting disc thickness is 2.5 mm.
WARNING! When cutting or slitting with cutting discs, always use the standard guard with additional
cover plate.
Discs
Abrasive cutting disc
Diamond cutting disc
Abrasive grinding disc
Diamond grinding disc
Wire brushes
Abrasive resin-fiber disc
Suitability of discs for the equipment used
Item Equipment
A Guard
B Front cover (in combi-
nation with A)
C DG-EX 115/4.5" dust
hood for grinding (only
for 115 DG-CW)
D DC-EX 125/5"C dust
hood for cutting (only
in conjunction with A)
E Side handle
F Clamping nut
G Clamping flange
H Clamping nut for
abrasive resin-fiber
disc
I Support plate
5 Technical data

5.1 Angle grinder

Note
For rated voltage, frequency, current and input power, please refer to the country-specific type
identification plate.
Printed: 08.09.2017 | Doc-Nr: PUB / 5373328 / 000 / 00
4
Application Designation
Cutting, slitting AC­D
Cutting, slitting DC-TP, DC-D (SPX,
SP, P)
Rough grinding AG­D, AF­D, AN­D
Rough grinding DG-CW (SPX, SP, P)
Wire brushes 3CS, 4CS, 3SS, 4SS
Rough grinding AP-D
AC­D AG­D, DG-CW
AF­D, (SPX, SP,
AN­D
X X
X —
— —
— —
X X
X X
X X
— —
— —
Material
Metal
Mineral
Metal
Mineral
Metal
Metal
DC-TP, AP-D
DC-D
P) (SPX, SP,
P)
X X
— X —
X — —
— X —
X X
X X —
X X —
— —
— —
3CS, 4CS,
3SS, 4SS
X X
—
—
—
X X
—
—
X —
X —
English 21