Technical Data; Angle Grinder - Hilti DCG 180-D Original Bedienungsanleitung

3.7 Guard with cover plate (accessory)
When grinding with straight grinding discs and cutting with cutting discs in metalworking applications,
use the guard with cover plate.
4 Consumables
Use only synthetic-resin-bonded, fiber-reinforced discs with a maximum Ø of 180 mm approved for a
rotational speed of at least 8500 rpm and a peripheral speed of 80 m/s.
The maximum permissible grinding disc thickness is 8 mm and the maximum permissible cutting disc
thickness is 3 mm.
ATTENTION! When cutting or slitting with cutting discs, always use the guard with cover plate.
Discs
Abrasive cutting disc
Diamond cutting disc
Abrasive grinding disc
Diamond grinding disc
Suitability of discs for the equipment used
Item Equipment
A Guard
B Guard with cover plate
C Side handle
D DC BG hoop grip (optional
for C)
E Clamping nut
F Clamping flange
G Kwik lock (optional for E)
5

Technical data

5.1

Angle grinder

When powered by a generator or transformer, the generator or transformer's power output must be at
least twice the rated input power shown on the rating plate of the power tool. The operating voltage of
the transformer or generator must always be within +5% and -15% of the rated voltage of the power
tool.
The information given applies to a rated voltage of 230 V. The data may vary in the event of deviations
from the rated voltage and for country-specific versions. Please refer to the power tool's type
identification plate for details of its voltage, frequency, current and input power ratings.
Rated power input
Rated speed
Maximum disc diameter
Weight in accordance with EPTA procedure 01
Drive spindle thread
Thread length
5.2 Noise information and vibration values determined in accordance with EN 60745
The sound pressure and vibration values given in these instructions have been measured in accordance with
a standardized test and may be used to compare one electric tool with another. They may be used for a
preliminary assessment of exposure.
22 English
Printed: 29.03.2018 | Doc-Nr: PUB / 5069492 / 000 / 03
2
Application Designation
Cutting, slitting AC­D
Cutting, slitting DC­D
Rough grinding AG­D, AF­D, AN­D
Rough grinding DG­CW
AC­D AG-D AF-D
— X
X — —
X X
X X
X X
X X
X X
Material
Metal
Mineral
Metal
Mineral
AN-D DG­CW
X X X
— —
X X X
X X X
X X X
X X X
X X —
DCG 180-D/P
2,200 W
8,500 /min
180 mm
5.7 kg
M14
25 mm
71878
DC­D
X
X
X
X
X
X
X
*71878*