WIKA CPH7600 Betriebsanleitung Seite 19

6. Commissioning, operation
Here the "SELECT" option will switch between the available choices for each
parameter. The first parameter is "MODE". Since voltage, current and switch test
modes all use the same leads, two of these functions cannot be used concurrently.
The ability to select certain functions is limited and dependent upon what is already
selected in the other display sector. The "NEXT" option is used to change to the second
parameter. Only the pressure modes have a second parameter.
Within any single display sector, the following modes are available:
P[1] = integrated pressure sensor
[EXT] = pressure with external pressure module
P[1] ST = switch test with integrated sensor
[EXT] ST = switch test with external pressure module
Current functions are only available on the lower display:
mA measurement = current measurement without voltage supply
mA w/24V = current measurement with voltage supply
mA Source = current source
mA sim = mA simulation using an external supply from the instrument under test
VOLT = voltage measurement
The following table shows which functions are available concurrently.
An "--" in a column indicates that the mode in the active display will not be available for
selection if the mode in that row is in use in any other display sector.
P[1]
[EXT]
P[1] ST
[EXT] ST
mA
mA-loop
Volt
6.1.2.3 Accessing other menus
In order to access further menus, select the "MORE" option in the main menu.
WIKA operating instructions, model CPH7600
Active display
P[1]
P[1] [EXT]
ST
  
  
--
 
--
 
--
 
--
 
--
 
[EXT]
mA mA-loop
ST
  
  
-- -- --
-- -- --
-- --

-- --

-- -- --
GB
Volt RTD
 
 
--

--

--

--

 
19