Support in the Sensor Value Settings:
The sensor settings must be adjusted individually to each application case.
To save costs (alarm text message) and time (IDLEALARM), use the function DIAGNOSE.
After it is activated, all sensor triggers are rerouted to the red „ERR" LED.
The following commands are needed to activate the DIAGNOSE mode:
SET DIAGNOSE #1513
ENABLE ALARM #1513
The following commands switch off the DIAGNOSE mode again:
DISABLE ALARM #1513
RESET DIAGNOSE #1513
All activated alarm sensors are rerouted with the current settings.
Differentiation of the sensors is not possible and therefore should be performed
separately.
When the red LED lights up (or, e.g., if „SHOCK" flashes), an alarm has been
recognised.
35