Renkforce GX111 Kurzanleitung Seite 31

Time Limit „IDLEALARM"
The function „IDLEALARM" serves to protect the customer from high alarm text message
costs. In the basic settings, this function is set to 2 minutes. This means that no sensor
can trigger the same alarm repeatedly within 2 minutes.
Example:
The „SHOCK" sensor is triggered every 15 seconds in this scenario. To avoid the customer
getting an alarm text message every 15 seconds (causing the corresponding costs), an
internal timer will start after the first alarm text message.
Within the next 2 minutes (basic settings), the „SHOCK" sensor cannot trigger any new
alarms. However, this only affects the „SHOCK" sensor. All other sensors continue to
be active and ready to trigger another alarm by text message.
The description for setting this function is found in the operating instructions
on the CD.
If the GX111 does not trigger any alarm text message, first check whether the
corresponding alarm was triggered already within the last 2 minutes (basic
settings). Only when the set time limit has expired will a new alarm text message
be sent.
This is often a reason for misunderstandings during the function test of the
GX111. Consider this conduct during programming or commissioning.
Text Message Command Format
The entire configuration of the GX111 can be performed by text message. The command
format looks as follows:
SET TEL1 +4911223344 #1513
This sets the phone book entry 1 to +4911....
TEST STATUS #1513
This serves to request the current status such as rechargeable battery capacity, tem-
perature, GSM signal, etc.
RESET TIMEOUT #1513
This resets the function TIMEOUT to the basic setting. The GX111 now wakes up for 15
minutes 1 x per day.
31