Factory Setting - Renkforce GX111 Kurzanleitung

After activation of tracking, the OFFLINE mode is deactivated. The rechargeable
battery runtime will reduce accordingly.
We recommend using a suitable USB power supply for extended operation of
the GPS receiver.
Only new data are written to the internal memory when the GPS receiver has
determined its position.

Factory Setting

The factory settings are reset with the buttons „RESET" and „S1".
Important!
The PIN of the GX111 is reset to the default value #1513 in the reset.
The PIN of the SIM card remains unchanged, however.
If you have set the SIM card's PIN to any other value than 1513, the GX111 will
no longer work after the reset, and you have to change the PIN of the GX111
accordingly!
To reset the GX111 to the factory settings via the buttons, proceed as follows (this must
be done within 3 seconds):
• Keep the button „S1" pushed.
• Briefly push the button „RESET".
• Release the button „S1" again.
If the button „S1" is pushed for more than 3 seconds in total, the GX111 will not
be reset to the factory settings, since it is assumed that you pushed the button
by accident.
After successful resetting to factory settings, a flashing pattern is output via the „ERR"
LED. The „ERR" LED flashes 3 times in quick sequence (250 ms on, 250 ms pause, etc.).
38