Commissioning - Renkforce GX111 Kurzanleitung

10. Commissioning

Step 1: Set the micro SIM card to PIN 1513.
The GX111 assumes a SIM card with the PIN 1513 in its basic settings. The PIN
therefore must be changed on a different mobile phone before inserting it into
the GX111.
Step 2: Insert the Micro-SIM card (with PIN 1513) into the GX111. Observe automatic
latching of the SIM card insert.
Step 3: The GX111 should start automatically after the Micro SIM card is inserted. This
can be told by the „ERR" LED flashing once per second (booting).
If no LED is lit:
• Check the SIM card latching in the card insert.
• Push the button „RESET".
• The rechargeable battery may be flat. Connect the GX111 to a USB port (e.g.
the USB port of a computer). The yellow „AKKU" LED should be lit now. Let
the rechargeable battery charge for at least 15 minutes.
• The rechargeable battery plug may have come loose. Observe Chapter 9.
The red LED light is lit permanently.
• A SIM error has been recognised. Either the PIN is wrong, the SIM card is
locked (PUK) or not activated. Check the SIM card with a different mobile
phone.
• A hardware error has been found (rare). Visit the download area at
www.conrad.com. There may be diagnosis software available there.
Step 4: If the green „GSM" LED flashes quickly (1 s), the device is trying to find the GSM
network. If the „GSM" LED flashes slowly (once every 3 s), the SIM card has been booked
into the GSM network. The GX111 is now ready for operation.
If the „GSM" LED flashes quickly permanently
• No GSM-reception.
• The SIM card may not have been activated. Please check it with a mobile
phone.
29