TechniSat DIGITRADIO 360 CD IR Bedienungsanleitung Seite 130

> Now enter the name (SSID) of your WLAN network with the r/s PRESET, VOL+, VOL- buttons and
confirm with OK.
> Select whether your WLAN network is Open, encrypted by WEP or by WPA/WPA2 and confirm the
following item.
> Now enter your WLAN password using the r/s PRESET, VOL+, VOL- buttons and confirm your selection
with OK to start the connection process.
In general, the WLAN connection can be used after a few seconds.
15.2.2.4 Display settings
> Select Display settings to display the current network settings.
15.2.2.5 NetRemote PIN setup
Under certain circumstances, it may be necessary to secure the connection to the DIGITRADIO with a PIN.
> Enter a 4-digit PIN in NetRemote PIN setup.
15.2.2.6 Delete network profile
Use this menu item to end an existing connection to a WLAN and to delete the settings made.
If you wish to connect the device to this network again, you must carry out all settings again.
15.2.2.7 Delete settings
Activate this setting to delete the access data to the set WLAN. All other settings are retained.
58