Interface Personalisation; Lock/Unlock; Alarms Screen - voestalpine Böhler Welding URANOS 2000 SMC Betriebsanweisung

3.9 Interface personalisation

1 7 segment display personalisation
Enter set-up by pressing the encoder button for at least
5 seconds.
Select the required parameter by rotating the encoder.
Store the selected parameter in the 7 segment display
by pressing button (2)
Save and exit the current screen by pressing button (4)
.
Default I1

3.10 Lock/unlock

Allows all the settings to be locked from the control panel with
a security password.
Enter set-up by pressing the encoder key for at least 5 seconds.
Select the required parameter (551).
Activate the regulation of the selected parameter by pressing the
encoder button.
Set a numerical code (password) by rotating the encoder.
Confirm the change made by pressing the encoder button.
Save and exit the current screen by pressing button (4)
The carrying out of any operation on a locked control panel
causes a special screen to appear.
.
.
- Access the panel functionalities temporarily (5 minutes) by
rotating the encoder and entering the correct password.
Confirm the change made by pressing button/encoder.
- Unlock the control panel definitively by entering set-up (fol-
low the instructions given above) and bring back parameter
551 to "off".
Confirm the changes made by pressing button (4)
Confirm the change made by pressing the encoder.

3.11 Alarms screen

Allows the intervention of an alarm to be indicated and provides
the most important indications for the solution of any problem
encountered.
1 Alarm icon
2 Alarm code
3 Alarm type
Alarm codes
E01, E03 Temperature alarm
It is advisable not to switch off the equipment while the alarm
is on; the internal fan will thus keep operating and will help to
cool the overheated parts.
E07 Wire feed motor supply alarm
E08 Blocked motor alarm
E10 Power module alarm
E13 Communication alarm
.
47