Jung Smart Visu Server Produktdokumentation Seite 92

RGB:
The "RGB" function (1) is the KNX function for controlling RGB dimmer actuators. With the
group address, e.g. "Transmit value red" (2), it is possible to write the current brightness
value of the red colour channel to the bus. The "Value red feedback" group address (3)
can be defined to read the current brightness of the red colour channel.
In addition, the current status of a selectable group address of the colour channel can be
polled by defining an initialisation address (4) on starting the system. The same applies to
the green (5 - 7) and blue (8 - 10) colour channel. The "Switching" group address (11) can
be defined for central switching of the function. The switching state of the function can also
be read via the "Switching feedback" group address (12).
Figure 76: Parameters of the "RGB (KNX)" function
The function possesses the following individualisation options within the icon library (13).
KNX
Selection of the icon library in SV-Control
function
RGB
SV- SERVER / SV-SERVER-INT
13
Table 34: Display of the "RGB (KNX)" function
1
2
3
4
5
6
7
8
9
10
11
12
Operating and display element in SV-Home
91 / 150