Troubleshooting - Klarstein Pure Blizzard 3 2G Bedienungsanleitung

End of Season Storage
• Screw off the drain cap, unplug the water plug and drain the water in the water tray
to another vessel that holds water. The tilt angle of the unit shall not be greater than
30 degrees.
• Start the unit, turn the mode to the low fan speed state of the air supply mode, keep
this state for half a day and dry the interior of the unit to prevent mold.
• Turn off the unit, unplug the power plug, wrap the power cord around the wire-
winding post, insert the plug into the universal jack at the back shell of the unit;
install the water plug and drain cap.
• Remove the heat exhaust hose assembly and keep it properly.
• Pack the air-conditioner properly with soft plastic bag, put the unit in a dry place
& take appropriate dust-proof measures, and keep the unit out of the reach of
children.
• Take out the batteries of the remote control and keep it properly.

TROUBLESHOOTING

Problem
The air-conditioner does
not work
Bad cooling or heating
effects
Cause
No power.
Full water indicator
illuminates.
Ambient temperature too
low ?
The room temperature
is lower than the set
temperature in the cooling
mode.
There is direct sunlight.
The doors and windows
are open, the room is
crowded or there are
other heat sources in the
cooling mode.
Remedy
Connect the unit to a live
socket and
turn it on.
Drain the water stored in
the unit.
It is recommended that this
unit be
operated at 10-35°C.
Change the set
temperature.
Draw the curtain on.
Close the door and
window and add new
air-conditioners.
EN
35