Klarstein Pure Blizzard 3 2G Bedienungsanleitung Seite 28

EN
28
Installation of the unit
Move the machine with the heat exhaust hose assembly installed before the window
and keep the unit at least 50 cm away from the walls or other objects. Snap the flat end
of the heat exhaust hose short connector into the elliptical hole of the window sealing
board assembly (see picture below).
Note: The flat end of the exhaust hose short connector must be snapped into
place. The heat exhaust hose may not be bent and shall be free from significant
(greater than 45°) flexure. The exhaust hose is 280-1500mm long and this length is
determined based on the specification of the air-conditioner. Do not use prolonged
hose or replace with other different hoses as this may affect the functions of the air-
conditioner. The exhaust must be smooth and the air-conditioner may overheat if the
exhaust is obstructed.