Prior To Use; Charging The Battery; First Use; Switching The Headphones On/Off - Silvercrest SBKN 4.0 A1 Bedienungsanleitung

SilverCrest SBKN 4.0 A1

Prior to use

Remove the headphones from the packaging and remove all packaging
material completely.

Charging the battery

Before the first use or when the built-in battery is empty, you charge it as
follows:
 Connect the supplied USB charging cable (C) to the micro USB charging
socket (8) and a free USB socket of your computer when it is switched on or
a USB power supply (not supplied).
 The LED (3) lights up orange while the battery is being charged. When the
battery is fully charged, the LED (3) goes out.
Never cover the headphones while they are charging as they can become
heated.
The orange LED (3) flashes when the battery is low.

First use

Switching the headphones on/off

Switch on the headphones by pressing the
seconds. You hear an ascending tone sequence in the headphones. The LED
(3) flashes blue and thus indicates standby mode. If the headphones were
switched on for the first time and had never been connected to a device,
pairing mode is started automatically. The LED (3) alternates between flashing
blue and orange in pairing mode. Read the next section when connecting your
device.
Press the ▸ll button (5) for at least 5 seconds to switch off the headphones.
You hear a descending tone sequence in the headphones.

Connecting headphones

Proceed as follows to connect the headphones to your device:
 Switch off the headphones.
72 - English
▸ll button (5) for at least three