Changing The Filter; Rinsing The Impressa - Jura IMPRESSA F55 Bedienungsanleitung

You can interrupt rinsing of the filter at any time by closing the
steam / hot water draw-off tap (14). To continue with filter rins-
ing, open the steam / hot water draw-off tap (14) again.
CLOSE TAP
Close the steam / hot water draw-off tap (14), your IMPRESSA will
now heat up to coffee temperature.
HEATING
READY
You have now activated the filter. In programming mode, the
Water hardness programme item
longer appears.

5.2 Changing the filter

After drawing off around 50 litres of water, the filter will cease
to work. You will be prompted to change the filter. Please use
the scale on the filter holder on the water tank to monitor
how long the CLARIS filter cartridge has been in use (max.
2 months).
READY
FILTER
Press the Maintenance button
appears:
CHANGE
OPEN TAP
Remove the water tank from the machine and empty it.
Fold up the filter holder. Take out the old CLARIS filter cartridge and
insert the new filter cartridge into the water tank, exerting slight
pressure (Fig. 1).
10
HARDNESS no
(3) until the following message
Close the filter holder until it audibly snaps into place.
Fill the water tank with cold, fresh mains water and reinsert in the
IMPRESSA.
Place a sufficiently large receptacle (around 1 litre) under the Pro-
fessional Cappuccino Frother (15) (Fig. 10) and open the steam / hot
water draw-off tap (14) (Fig. 13).
FILTER
RINSING
CLOSE TAP
Close the steam / hot water draw-off tap (14).
HEATING
READY

6. Rinsing the IMPRESSA

If the IMPRESSA is switched off and has already cooled down,
you are prompted to perform the rinse operation. A rinse oper-
ation is triggered automatically when shutting the coffee ma-
chine down.
Switch your IMPRESSA on with the On/Off button
HEATING
PRESS
RINSE
Press the Maintenance button
RINSING
READY
(21).
(3).