Replacing The Filter Cartridge; Disposal; Trouble-Shooting - Jura SUBITO Bedienungsanleitung

Bed.subito d/F/I/E/SP/NL 22.10.2001
17. Repeat Steps 15 and 16 twice.
18. Empty the vessel and reposition under the height-adjust-
able coffee spout.
Rinsing after decalcification
19. Rinse the tank thoroughly, refill with fresh water from the
mains supply and replace.
20. Turn the main switch ( ) on and heat approx. 200 ml of
water.
21. Turn the tapping switch off and wait until the heating
control lamp ( ) goes out.
22. Turn the tapping switch (
the contents of the tank.
23. Turn the tapping switch (
24. Empty the vessel and reposition under the height-adjust-
able coffee spout.
25. Unlock the twist-lever, and pull up. Then turn the cover
back into its initial position (Fig. 6).
26. Set the selector to the «Water position» (
27. Turn the tapping switch (
the contents of the tank.
28. Turn the main switch ( ) off and set the selector to the
«Coffee position» (
29. Drain the residual water tray and the grounds container
and replace.
30. Fill the water tank with fresh water from the mains supply
and replace.

11. Replacing the filter cartridge

● Swing the cartridge retaining clip up and fit the filter
cartridge into the water tank, exerting light pressure only.
● Swing the cartridge retaining clip back down, until it can be
heard clicking into position.
17:39 Uhr Seite 43
) on again and draw off 1 /
2
) off again.
).
) on and draw off the rest of
).
● The cartridge retaining clip is equipped with a special rotat-
ing disc to allow the date to be set for changing the cart-
ridge (2 months from date of fitting).
● Turn the tapping switch (
of the contents of the tank through the water and steam
spout.
NB: Filter cartridges are available from your local Jura dealer.

12. Disposal

You should return your coffee machine to a dealer, service
centre or the Jura company for correct disposal.
of

13. Trouble-shooting

"Empty grounds" ( ) warning lamp lights up:
–> Coffee grounds container is full
–> Coffee grounds container is missing
–> Residual water container has not been fitted correctly
No espresso/coffee comes out
–> Water tank has not been fitted correctly
–> Water tank is empty
–> Crank handle not correctly lowered for brewing
–> Cover is dirty (see section 9.3 "Cleaning cover").
–> Machine is furred up
–> Coffee ground too finely
Difficult to lower crank handle or to rotate the cover
–> Follow the instructions in section 9.3 "Cleaning cover".
If none of the remedies listed above help, please contact your
dealer or get in touch with the Jura Customer Service Depart-
ment direct.
1
) on and draw off approx. /
2
43
E