Sharpening The Saw Blade - EFA SK23/18 Betriebsanleitung

3. Remove the hex. nut using the single-head
wrench supplied - turn in anti-clockwise direc-
tion (arrow B). (see Fig. 3)
Figure 3: Loosening the saw blade
4. Replace the saw blade. Place the new saw blade
onto the square drive (see Fig. 4).
Figure 4: Fitting the saw blade
5. Insert the retention pin as a twist lock into the
saw blade bore and the bore below (A)
(see Fig. 5).
6. Tighten the hex. nut securely - turn in clockwise
direction (arrow B) and tighten to approx. 50
Nm (see Fig. 5).
A Medium-fine toothing
6-8 mm
D Low-noise
toothing
Schmid & Wezel
D-75433 Maulbronn
7. Remove single-head wrench and retention pin.
8. EFA SK23/ 18: Install the depth stop as
9. Connect the saw to the works mains again.
10.Carry out a test run.

3.2 Sharpening the saw blade

We have set up a sharpening service in our Service
department. Incorrectly resharpened saw blades
detract from your productivity and also constitute
considerable risks for the user.
An overview of our product range for saw blades
can be seen in Figure 6: Saw blades and Table 2:
EFA 30/ 18 :
B Medium-coarse toothing
12-20 mm
E Hard metal
toothing
Figure 6: Saw blades
Seite/ Page
19/ 34
Figure 5: Fixing the saw blade
described in chapter 3.3.1 "EFA SK23/ 18:" (p.
20).
C Coarse toothing
40-45 mm
Ausführung/ Version
02.2014