Important Notices - Radiodetection RD7000+ Bedienungsanleitung

CALSafe
CALSafe enabled RD7000+ (PLM and TLM models only) are equipped with a system
which does not permit them to function once they are beyond the expected service/
calibration date.
When the unit is within 30 days of the service due date the unit will display at startup the
number of days left. The locator will stop functioning on the service due date.
You can edit the CALSafe service due date or disable this function using the RD Manager
PC software. Refer to its operation manual for further information.
Automatic Logging
RD7000+ logging models (PLM and TLM) offer a powerful data logging system which
records all the instrument's critical parameters and warnings in its internal memory at the
rate of 1/sec.
The automatic logging system is always active and cannot be disabled. Its memory is
capable of storing at least 1 year's worth of normal usage data – based on 4 hours
operation per day, 5 days per week, 20 days per month.
Logs can be retrieved using the RD Manager PC application for usage analysis and
survey validation. Refer to its operation manual for further information.

Important notices

When reporting any problems to your Radiodetection Dealer or Supplier it is important to
quote the unit serial number and the purchase date.
This instrument, or family of instruments, will not be permanently damaged by reasonable
electrostatic discharge and has been tested in accordance with IEC 801-2. However,
in extreme cases temporary malfunction may occur. If this happens, switch off, wait and
switch on again. If the instrument still malfunctions, disconnect the batteries for five
seconds and then reinstall and switch the unit on.
Compliance
EU Compliance
This equipment complies with the following EU Directives:
• R&TTE Directive: 1999/5/EC
• Low Voltage Directive: 2006/95/EC
• EMC Directive: 2004/108/EC
20
FCC Compliance Statement
This equipment complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
• The equipment may not cause harmful interference.
• The equipment must accept any interference received, including interference that
may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits
for a Class A digital device pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the manufacturer's instruction manual, may cause
harmful interference with radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference, in which case you will be
required to correct the interference at your own expense.
Modifications:
Any modifications made to this equipment not approved by Radiodetection may void the
authority granted to the user by the FCC to operate this equipment.
Industry Canada Compliance Statements
ICES-003 Class A Notice:
This Class A digital apparatus complies with Canadian ICES-003.
Avis NMB-003, Classe A: Cet appareil numérique de la classe A est conforme à la norme
NMB-003 du Canada.
Training
Radiodetection provides training services for most Radiodetection products. Our qualified
instructors will train equipment operators or other personnel at your preferred location or
at Radiodetection headquarters. For more information go to www.radiodetection.com or
contact your local Radiodetection representative.
21