General Information - FLUX FMJ 100 Betriebsanleitung

2.2 The Operating Concept
All of the settings are inputted using the following operating concept
Process
3

General Information

The Stop key can be pressed at any time and is not shown for this reason.
Pressing the key once moves you back one step..
If this symbol appears on the display, the PIN must firstly be entered
before processing.
For setting, refer to the [SET] group in chapter 5 -> PIN No. (5.1) and Secu-
rity Level (5.2)
Operation of the unit is permitted when this symbol is shown on the
display.
This symbol flashes if pulses are detected at the input.
The display is switched off if no pulse is measured or if no key is
pressed for 5 minutes. The display switches on again as soon as a
pulse is detected or a key pressed.
The unit cannot be operated when pulses can still be measured and the SET range
is not displayed. The unit can be operated one second after the last pulse was meas-
ured and the SET range can be accessed again.
If no entries are made during operating in a group for one minute, the unit automatically
switches over to [RUN].
Select Process
(left/right
up/down)
Attachment FLUXTRONIC FMJ 100
.
RUN
Operate Default display
25 / 60