Operation; Troubleshooting - Klarstein Frosty Bedienungsanleitung

OPERATION

• The refrigerator will have better performance at ambient of 20-25 degrees. We
suggest the refrigerator be powered off if the ambient temperature is lower than 10
degrees.
• After plugging the appliance, allow the unit to cool down for 2-3 hours before
placing beverage into the refrigerator compartment.
• Ventilation is very important for this kind thermoelectric refrigerator. The inside
PCB will be broken easily if the ventilation is bad; It will also reduce the life of the
refrigerator.
• The refrigerator applies automatic defrosting system, so there is no need to defrost it
manually.

TROUBLESHOOTING

Problem
Appliance does not work.
The food is too warm.
Appliance cools too much.
Unusual noises.
Possible cause
Mains plug is not plugged in
or is loose
Fuse has blown or is defective
Temperature is not properly
adjusted.
Door was open for an
extended period.
A large quantity of warm food
was placed in the appliance
within the last 24 hours.
The appliance is near a heat
source.
Temperature is set too cold.
Appliance is not level.
The appliance is touching the
wall or other objects.
A component, e.g. a pipe, on
the rear of the appliance is
touching another part of the
appliance or the wall.
Solution
Insert mains plug.
Check fuse, replace if
necessary.
Please look in the initial
Temperature Setting section.
Open the door only as long as
necessary.
Turn the temperature regulation
to a colder setting temporarily.
Please look in the installation
location section.
Turn the temperature regulation
knob to a warmer setting
temporarily.
Re-adjust the feet.
Move the appliance slightly.
If necessary, carefully bend
the component out of the way.
EN
13