Transport And Installation; Operation - Klarstein PopArt Bedienungsanleitung

TRANSPORT AND INSTALLATION

• Make sure the refrigerator is kept upright during handling. If an inclination is
required, it should not exceed 45 degrees. Otherwise the appliance may get
damaged resulting not only in compromised refrigeration performance.
• To avoid product damage or personal injury, the refrigerator should be unpacked
by two persons after it is located in a previously selected position.
• Remove all packing materials.
• Checking should be conducted with reference to the Packing List. Contact the local
distributor if discrepan- cies are found.
• Before installation, make sure the refrigerator has no visible exterior damage.
• When handling the refrigerator, do not lift it by holding the worktop, to prevent any
damage to the refrig- erator.
• Do not start up a refrigerator that is damaged.
• Install the refrigerator in a well-ventilated place.
• Clean the refrigerator before use. (See the section "Cleaning")
• After the refrigerator has been sited and cleaned, let it stand for more than 30
minutes before connecting the power source.

OPERATION

Starting the refrigerator
After connecting to the power supply, turn the temperature controller clockwise from
position 0 to any posi- tion between 1 and 7 to start the refrigerator. The refrigerator
compressor will stop when the temperature controller is at position 0.
Adjusting the temperature
The temperature inside the refrigerator is adjusted by turning the temperature controller.
Positions 1 to 7 represent different temperatures from the lowest to the highest.
0 Off
1-2 Summer or ambient temperature between 25-35 °c.
3-4 Spring, autumn or ambient temperature between 15-25 °c.
4-5 Winter, or ambient temperature between 5-15 °c.
6-7 Quick freeze
EN
23