Qlima A 34 Gebrauchsanweisung Seite 45

Pre-filter Changing Indicator
HEPA Filter Changing Indicator
Sleep Mode
Child Lock
CLEANING
Keep the air purifier functioning properly by changing the Pre-filter and HEPA Filter when
the filter changing indicator turn on. More frequent replacement will be necessary if the
unit is located in an area with a high level of airborne contaminants (excessive amounts of
smoke, pet dander, etc.).
Exposing the air purifier to candle/oil/fireplace soot and smoke is not recommended and
will require more frequent cleaning.
G
Always make sure the air purifier is turned off and unplugged before changing
filter.
• Do not use water or any household cleaners or detergents to clean the Pre-
filter and HEPA Filter.
• The inlet grill may be cleaned (after unit is turned off and unplugged) with a
vacuum or a slightly damp cloth.
CHANGING THE HEPA FILTER
1. Release the inlet grill by pressing on the locking latch (see diagram of Main Parts).
2. Remove the inlet grill from the unit as shown below.
3. Grasp the left and right frames of the HEPA Filter through the indentations on the
sides of the filter enclosure and remove the filter.
4. Insert new HEPA Filter into the unit. Make sure it is the correct installation direction.
5. Reattach the Rear Cover of the unit and securely latch into place.
6. Push and hold HEPA FILTER Button for 3 seconds to reset HEPA Filter Change Indicator.
play.
The Pre-filter Changing Indicator will turn on each
time the Pre-filter needs to be changed. To reset
the pre-filter indicator, press the PRE-FILTER button
for 3 seconds, then the Pre-filter Changing Indica-
tor will turn off completely, indicating the unit has
been reset.
The HEPA Filter Changing Indicator will turn on
each time the HEPA Filter needs to be changed.
To reset the HEPA Filter indicator, press the HEPA
FILTER button for 3 seconds, then the HEPA Filter
Changing Indicator will turn off completely, indicat-
ing the unit has been reset.
If you want to sleep with silent and dim condition,
please press Sleep Mode button to activate it. Then
the speed would turn to low and the lights would
be dim. Press again Sleep Mode button would exit
Sleep mode.
Press the Sleep Mode button for 3 seconds to acti-
vate the Child lock ,and press again for 3 seconds to
exit Child lock.
4
45 45