Hair Trimmer With Blade Unit - Silvercrest SHSK 3.7 A1 Bedienungsanleitung

7.3 Hair trimmer with blade unit

Replacing the blade unit
You can reorder a new blade unit 1 (see "Ordering accessories"
on page 48).
• Figure B: press the release buttons 4 and pull out the blade
unit 1.
• Slide the new blade unit 1 into the hair trimmer from the
front until it clicks into place.
Dry cleaning of the blade unit
• Use the cleaning brush 9 supplied to remove residual hairs
from the blade unit 1 after every use.
Wet cleaning of the blade unit and hair trimmer
The hair trimmer and blade unit 1 may be cleaned under clean
running water.
1. Remove the comb attachment 7, if necessary.
2. Clean the blade unit 1 and the hair trimmer under running
water.
3. Allow the parts to dry completely.
Oiling the blade unit
For oiling, use the oil 10 supplied, or an acid-free oil, e.g. sew-
ing machine oil.
• Every 6 months or so, apply a few drops of oil onto the cut-
ting blade of the blade unit 1 from above.
• Switch the device on for a few minutes to spread the oil
around.
• Using a soft, lint-free cloth, wipe off the surplus oil, if neces-
sary.
43
GB