Technical Data; Temperature Adjustment; Operation And Settings; Replacement Parts - Grohe EUROECO COSMOPOLITAN E series Installationsanleitung

The transceiver operates in the ISM-frequency range
(2.4GHz). The installation near devices with the same
frequency band (eg wireless devices, DECT phones, etc.
(observe manufacturer documentation)) should be avoided.

Technical data

• Voltage supply: 100-240 V AC 50-60 Hz/6.75 V DC
• Power consumption:
®
Bluetooth :
• Power consumption:
• Output:
®
• Bluetooth - version:
® -
• Bluetooth Transmission distance:
(depending on the environments)
• Automatic safety shut-off:
(6 - 420 s adjustable)
• Run-on time (0 - 19 s adjustable):
• Reception range according to Kodak Gray Card,
grey side, 8x10", landscape (15 - 35cm adjustable):
Thermal disinfection possible.
Electrical test data
• Software class
• Contamination class
• Rated surge voltage
• Temperature of ball impact test
The test for electromagnetic compatibility (interference emission
test) was performed at the rated voltage and rated current.
Fault / Cause / Remedy
Fault Cause
Water not flowing • Filter in solenoid valve blocked
• Solenoid valve defective
• Plug-in connector without contact
• No voltage
- Power supply unit defective
- Power supply switched off
Undesired water • Sensor system detection zone set too high
flow for local conditions
• Automatic flushing activated
• Solenoid valve defective
Flow rate too low • Mousseur dirty
• Filter in solenoid valve dirty
• Filters in connection hose dirty
3
Installation
Plaster and tile the wall, excluding the area of the
structural shell protection.
Flush pipes thoroughly before and after
installation (observe EN 806)!
Open hot and cold water supply and check that
connections are watertight.
4 W

Temperature adjustment,

see fold-out page II.
1 W
®
Bluetooth - Class 2

Operation and settings,

4.0
see technical product information, 99.0409.xxx /
about 10m
99.0438.xxx
Activating setting mode
60 s
Disconnect the power supply to the electronics and reconnect
after 10 s.
1 s
The indicator lamp in the sensor system illuminates in setting
mode when the detection zone of the fitting is reached by an
25cm
approaching user.
Setting mode is automatically terminated after 3 minutes..
Maintenance
•Shut off water supply.
A
•Disconnect voltage supply.
2
•Inspect and clean all components and replace if
2500 V
necessary.
100 °C

Replacement parts

see fold-out page I (* = special accessories)
,
Care
For directions on the care of this fitting, please refer to the
accompanying Care Instructions.
Remedy
- Clean filter
- Replace solenoid valve
- Check plug-in connector
- Replace power supply unit
- Switch on voltage supply
- Reduce range using remote control (special
- Wait 1 - 10 minutes
- Replace solenoid valve
- Clean or replace mousseur
- Clean filter
- Clean or replace filters
, see fold-out page I - II.
, see fold-out page II.
accessory, prod. no.: 36 407) / app