Seat Positions (Adjusting The Seat Into Sitting And Reclining Positions); Removing Your Child; Maintenance; General - Maxi-Cosi PrioriFix Gebrauchsanweisung

B. Placing your child in the PrioriFix
38 • Slide the buckle sections together (38,1) and "click" them into the belt buckle (38,2).
• IMPORTANT! Position the lap belt part of the harness system as low as possible (39) to ensure the hips sit
39
firmly in the seat!
• Pull the shoulder belts tight (40,1) and remove any remaining slack by pulling them tightly using the
40
adjuster belt (40,2).
• IMPORTANT! Make sure you can fit only one finger between the harnesses and your child. The tighter the
belts fit around your child, the better the protection.
• IMPORTANT! Make sure the textured side of the belt pads are positioned properly on your child's
shoulders/chest.
• IMPORTANT! Make sure the belts are not twisted.
If you are unable to fasten the harness belts properly or pull them tight, contact your supplier immediately.
Do not use the PrioriFix under any circumstances.
Always use the belt pads, as they are essential to your child's safety.
Instruct your child to never play with the belt buckle.

4.2 Seat positions (adjusting the seat into sitting and reclining positions)

41
The PrioriFix can be adjusted to 4 different positions (41).
42
• Pull the positioning handle under the front of the seat upwards (42,1) and then pull or push the seat
forwards or backwards (42,2).
• Release the positioning handle in the desired position and push until you hear a "click".
• IMPORTANT! Check to make sure the PrioriFix is securely locked in the desired position by pulling on it.
Checklist...
To ensure the optimal safety of your child, check before every trip to make sure that...
• The entire PrioriFix is installed securely and firmly in the car.
• The height of the shoulder belts is suitable for your child.
• The belts are not twisted.
• The belt pads are positioned properly with the textured side against your child's shoulders.
• Your child is securely fasted with the harnesses and the belt buckled is properly locked.
• The tether on the PrioriFix is not damaged. If so, do not use the PrioriFix under any circumstances and
contact your retailer or importer immediately.

4.3 Removing your child

• Place the PrioriFix in the sitting position (also see section 4.2: Seat positions).
43
• Release the belt buckle (43) by pressing the red button on the buckle.
28 • Loosen the shoulder belts by pressing the release button and pulling the shoulder belts towards you as far
as possible (28).
44 • Drape the belts over the hooks on the shell (44).
45
• Pull the buckle forwards and pull the buttonhole over the hook (45).
• Remove your child from the PrioriFix.

5. MAINTENANCE

5.1 General

• IMPORTANT! Always remove the PrioriFix from the car before carrying out any of the following.
• Use lukewarm water, soap and a rag to clean the plastic parts of the seat. Do not use abrasive cleaners.
• IMPORTANT! Never use lubricants, not even for the moving parts on the PrioriFix.
Instructions for use
GB
13