Checking Display Accuracy; Service Parts And Parts Subject To Wear; Technical Data; Disposal - Bosch RTM 430 Produktbeschreibung

7. Fit the catch pan back onto the underside of the
device and tighten the screws.
8. Attach the connecting cable between the RTM 430
and ESA, FSA, BEA or EAM.
5.5

Checking display accuracy

i
The calibration pin 1 688 130 220 can be used to
check the RTM 430's display accuracy. If the value is
out of tolerance, then the RTM 430 has to be clea-
ned. The procedure for checking measuring accuracy
is described in each relevant program description.
5.6

Service parts and parts subject to wear

Designation
Car exhaust-sample probe
Exhaust-sample hose
Ø 10 mm, length 1 m (<)
RTM 430 connecting cable (8 m) (<)
Cover (<)
Cleaning brush (<)
Calibration pin
Parts subject to wear
(<)
Robert Bosch GmbH
6.
Measured variable
Degree of opacity
Coefficient of absorption k
Designation
Measuring chamber length
Power supply
Operating temperature
Relative air humidity
of ambient air
max. exhaust tempera-
ture at device entry
Class of protection
Dimensions:
(W x H x D in mm)
Weight
Noise emissions
6.1
Order number
1 680 790 044
1 680 703 047
1 684 465 467
1 680 021 003
1 687 929 006
1 688 130 220
Maintenance | RTM ��� | 17 RTM ��� | 17

Technical data

Measurement
range
0 – 100 %
0 – 10 m
Value
432 mm
See installation instructions
1 689 978 425 and
1 689 978 427
+2 °C to +40 °C
< 90 % without thawing
200 °C
IP 33
594 x 203 x 151
approx. 8 kg
< 70 dB(A)

Disposal

This RTM ��� is subject to European guideli-
nes 2��2/96/EG (WEEE).
Old electrical and electronic devices, including-
cables and accessories or batteries must be
disposed of separate to household waste.
¶
Please use the return and collection sys-
tems in place for disposal in your area.
¶
Damage to the environment and hazards to
personal health are prevented by properly
disposing of RTM 430.
1 689 979 651
| 17 en
Resolution
0,1 %
0,01 m
-1 -1
|
2009-04-06