Operation - Grohe Tectron 38 386 Anleitung

GB
Fold out pages:
Type approvals
The system may only be operated in the following countries:
Germany, France, Belgium, Spain, Italy, Netherlands, Denmark,
Norway, Switzerland, Austria and Portugal.
Safety notes
• Installation is only possible in frost-free rooms.
• The control electronics are only suitable for indoor use.
• In the case of damage to the external transformer and
control unit connection cable, this must be replaced by the
manufacturer or his customer service department or an
equally qualified person, in order to prevent a hazard.
• When cleaning the fitting (the urinal) it must be ensured that
the tile frame behind which the electronics are installed is
not sprayed directly with water.
• In order to provide optimum water protection, the tile frame
must be sealed.
• Use only genuine replacement parts and accessories.
The use of other parts will result in voiding of the warranty
and the CE identification.
Technical Data
• Supply voltage:
(transformer 230 V AC/12 V AC)
• Power consumption:
• Operating frequency:
• Reception range:
(adjustable from step 1 – 9)
• Flow volume:
(adjustable 1 – 7 l)
• Intermediate flush:
• Automatic flush:
• Type of protection:
Electrical test data
• Software class:
• Contamination class:
• Rated surge voltage:
• Temperature of ball impact test:
The test for electromagnetic compatibility (interference
emission test) was performed at the rated voltage and rated
current.
5
Approval and conformity
This product conforms to the requirements of the
relevant EU guidelines.
The conformity declarations can be obtained from the
following address:
GROHE Deutschland Vertriebs GmbH
Zur Porta 9
D-32457 Porta Westfalica
Special accessory - infrared remote control
The following settings can be made and changed with the
infrared remote control (Prod. no. 36 206):

Operation

The subsurface-installed sensor monitors the detection range
and detects movements. If the user remains within the
detection range for longer than 7 s (= minimum delay time),
230 V AC, 50/60 Hz
the solenoid valve opens and the bowl is flushed:
- Approx. 1 s after the user moves away
3.2 VA
- After approx. 5 s, if the sensor does not detect any
24.075 GHz to 24.175 GHz
Step 5
- After 2 min, if constant movement is detected
3 l (factory setting)
Operating display flashing signal
The indicator lamp (A1) in the display (A2) of the electronic
Every 2 min (max. 14x)
module (A) displays the three operating states, see fold-out
(factory setting: activated)
page II, Fig. [1]:
24 hours
- Standby: a flashing signal approx. every 2 seconds
(factory setting: activated)
- Movement detected in front of the urinal (user approaching):
IP 54
- User detected and minimum dwell time elapsed:
A
2
2500 V
100 °C
New installations
Plaster and tile the wall, excluding the area of the structural
shell protection. Do not obstruct the inspection aperture for
electronic module.
Do not cover the sensor during installation behind the urinal.
0682
! ; 0700 !
- Set reception range (steps 1 – 9)
- Set flush duration (flow volume 1 – 7 l)
- Trigger flushing
- Switch off fitting
- Restore basic setting
- Test mode = waterless simulation
- Switch on/off 24-hour flush
- Switch on/off intermediate flush
- Switch on/off pre-flush
- Set minimum delay time
movement
a flashing signal every seconds
two flashing signals every second