Troubleshooting - Abicor Binzel TMS-VI Betriebsanleitung

Front Injector TMS-VI

10 Troubleshooting

Fault
No spraying function
No spraying function
Spraying function is not
switched on/off
Spraying unit is leaking
Tab. 8 Troubleshooting
DANGER
Risk of injury and machine damage when handled by
unauthorized persons
Improper repair work and modifications to the product may lead to serious
injuries and damage to the device. The product warranty will be rendered
invalid if the unit is handled by unauthorized persons.
• Operating, maintenance, cleaning and repair work may only be carried
out by qualified personnel (in Germany see TRBS 1203).
Please observe the attached 'Warranty' document. In the event of any doubts
and/or problems, please contact your retailer or the manufacturer.
NOTICE
• Please also consult the operating instructions for the welding
components, such as the power source, welding torch system, re-
circulating cooling unit etc.
Cause
• Check the fill level
• Hose connections open
• Air-blast hose kinked
• Output signal is active
• 5/2-way valve without function
• Screws are not tight
• Improper mounting
10 Troubleshooting
Troubleshooting
• Top up the anti-spatter fluid
• Close the compressed air
supply
• Check hose guide
• Check system control
• Replace 5/2-way valve if
required or check control line
• Retighten
• Mount on a vibration-free
mounting surface as specified
EN - 19