Installation - Abicor Binzel TMS-VI Betriebsanleitung

6 Putting into operation

6.1 Installation

EN - 12
CAUTION
Risk of injury
Physical injury due to parts falling or spinning around.
• Avoid abrupt lifting and setting down.
• Transport the components in an upright position.
• Do not lift the components over persons.
• Wear your personal protective equipment: safety shoes with steel toe
caps, protective work gloves.
NOTICE
• Ensure clear access to the control elements and connections.
• Only use the device in dry, clean and well-ventilated rooms.
• Makes sure that the injector axis is fastened precisely vertically.
• Select a site with a short approach distance in the work area. Depending
on the surface contact geometry of the mounting surface, the mounting
bracket allows horizontal or vertical mounting. This will position the Front
Injector TMS-VI vertically.
1
4
1 Flow regulator
2 2 cylinder head screws M6
Fig. 4 Putting into operation
1 Screw Front Injector TMS-VI into place with two screws (2) on a vibration-
free mounting surface (3).
Front Injector TMS-VI
2
3
3 Mounting surface
4 5/2 directional valve