Troubleshooting - Abicor Binzel TMS-VI Betriebsanleitung

Front Injector TMS-VI
9.1 Regularly
9.2 Weekly

10 Troubleshooting

Fault
No spraying function
No spraying function
Tab. 9 Troubleshooting
DANGER
Risk of injury due to unexpected start-up.
For the entire duration of maintenance, servicing, dismounting and repair
work, the following instructions must be adhered to:
• De-energize the work area of the robot.
NOTE
• The maintenance intervals given are approximate values and refer to
single-shift operation.
• Maintenance and cleaning work may only be carried out by qualified
and trained specialists.
• Always wear your personal protective clothing when performing
maintenance and cleaning work.
1 Check level of anti-spatter agent and top it up when required.
1 Remove adhering welding spatter.
NOTE
• Some problems are listed below, with descriptions of possible causes
and solutions. If the measures described below are not successful, please
consult your dealer or the manufacturer.
• Please also consult the operating instructions for the welding
components, such as the power supply, welding torch system, re-
circulating cooling unit, etc.
Cause
• Check level
• Hose connections open
• Air-blast hose bent
10 Troubleshooting
Solution
• Top up anti-spatter agent
• Close the compressed air
supply
• Check hose guide
EN - 11