Cooling Mode; Heating Mode; Timer Mode - DeLonghi Kyoto PLK130 Bedienungsanleitung

COOLING MODE

To activate the cooling function (COOL), press the MODE but-
ton until the symbol ( ) appears on the display.
To change the temperature value, use the
Each time the buttons are pressed the set temperature value
increases or decreases by 1°C.

HEATING MODE

To activate the heating function (HEAT), press the MODE
button until the symbol ( ) appears on the display.
To change the temperature value, use the
tons. Each time the buttons are pressed the set temperature
value increases or decreases by 1°C.
The appliance is fitted with a Hot Start function, which de-
lays appliance start-up for a few seconds to ensure an im-
mediate output of hot air.

TIMER MODE

Before setting the timer, ensure that the time on the re-
mote control is set correctly. If it is not, consult the in-
structions given on page 6.
Automatic switching-on
To set the automatic switching-on of the air conditioner, pro-
ceed as follows:
- With the appliance switched off, press the TIMER ON
( ) button.
- Set the automatic switching-on time using the
buttons.
- Press the TIMER ON button within 5 seconds to confirm
otherwise the function will exit from time setting (during
this procedure the unit confirms successful reception by
emitting a "Beep").
Note: to cancel the function setting, press the TIMER ON
button again.
Automatic switching-off
To set the automatic switching-off time, proceed as follows:
- Press the TIMER OFF (
- Set the automatic switching-off time using the
buttons.
- Press the TIMER OFF button within 5 seconds to confirm
otherwise the function will exit from time setting (during
this procedure the unit confirms successful reception by
emitting a "Beep").
Note: to cancel the function setting, press the TIMER OFF
button again.
and buttons.
and but-
and
) button.
and
!
Note: it is also possible to set the appliance switching-on
and switching-off time so as to define a specific
duration of operation.
Note: the appliance will start in the mode of operation that
was selected before switching off.
USER
USER
USER
9